Hi dafont my font Dolce & Amyara was rejected because you said "incorrect ascender/descender settings" I have checked it few times but i can't find the problem you mentioned, i don't see my font is cropped and nothing problem with the ascender/descender. Could you tell me where the problem exactly is? thanks
hishand studio said incorrect ascender/descender settings
Hi dafont my font Dolce & Amyara was rejected because you said "incorrect ascender/descender settings" I have checked it few times but i can't find the problem you mentioned, i don't see my font is cropped and nothing problem with the ascender/descender. Could you tell me where the problem exactly is? thanks
Hello, I have no relation to dafont, but try checking in notepad / ms word
Plotomad said hishand studio said incorrect ascender/descender settings
Hi dafont my font Dolce & Amyara was rejected because you said "incorrect ascender/descender settings" I have checked it few times but i can't find the problem you mentioned, i don't see my font is cropped and nothing problem with the ascender/descender. Could you tell me where the problem exactly is? thanks
Hello, I have no relation to dafont, but try checking in notepad / ms word
thank you! already solved.
metaphasebrothel said The old school way that I set ascenders and descenders:
For the glyph frame which has the highest ascender, and the one with the lowest descender, I move the top and bottom bearings to the highest and lowest positions, then I create a tiny contour in the upper or lower corner where that X Axis position intersects with the Y Axis position for the right or left side bearing. I save the project file, then delete the tiny contours, and save again. To me, that's easier than calculating a numeric value.
Thanks for the advice, really appreciate it!
All times are CEST. The time is now 21:26